亚洲AV欧美AV天堂

<progress id="nicqk"></progress>
    1. <optgroup id="nicqk"></optgroup>


        1. GLOSSARY

          Pellet Rolls & Shells

           
           

          Single or double rolls (also known as pellet shells) mounted inside the die ring on a cam or eccentric, turn on a rotating shaft as friction develops (due to the presence of feed between roll and die). Feed is forced through the die holes in increments so that dissection of a finished pellet shows tight layers of feed mixture. The die is driven by a motor and the rolls turn only as feed between rolls and die develops friction.

          Pellet rolls

          Pellet roll cross section

          Pellet rolls specifications:

          See the picture on the right for actual positioning on a pellet shell.

          I.D. = Inner Diameter of the Roll: The inside diameter is the most common identifying dimension of a pellet roll and is always specified during die selection.

          O.D. = Overall Diameter of the Roll: The diameter of the pellet roll/shell.

          W = Pad Width: The width of the pad.

          The outside of the roll is the edge of the roll that comes into contact with the feed and forces the feed into the inlets of the pellet die. There are a number of different patterns / configurations of this outside edge of a pellet shell.

          These include:
          - Corrugated (Open end)
          - Corrugated (Closed end)
          - Standard (Dimple)
          - Tungsten
          - Corrugated (helical, closed end)
          - Pinnacle

           

          Pellet shells
           
          Browse more related products
           
          opens in a new window or tab
          feedmachinery.com
          • 2020 ? FeedMachinery.com. All Rights Reserved.
          亚洲AV欧美AV天堂

          <progress id="nicqk"></progress>
          1. <optgroup id="nicqk"></optgroup>